Gas Furnace Sediment Trap

It was brought to my attention this morning that my furnace does not have one.

Gas furnace sediment trap.

These are pipe extensions that aim gas flow straight down. Sediment trap fau furnace and water heater although this picture shows a sediment trap on a water heater you will build or install this same way for your fau furnace. To experience the ongoing benefits of a gas condensing boiler you ll need to make sure it stays in good condition and among other things this means keeping the boiler condensate trap clean. The most frequent improperly configured sediment trap is where the gas supply connects to a tee fitting installed with the tee tap facing down the gas supply is connected to one end of the horizontal tee the appliance is connected to the other end of the horizontal tee and a short nipple is installed into the down facing tee tap the nipple is then capped.

Sediment traps installed at gas appliances are used to help catch any sediment or debris that may be present in the gas line and prevent it from entering the appliance and possibly damaging it. Sediment trap is the correct term for the code required trap. Sediment traps are used to well trap sediment from gas lines. The inlet gas line must have a minimum length of three 3 inches 7 6 cm drip leg sediment trap installed as close to the water heater s gas valve as possible.

It is actually a very useful component of the gas line known as a sediment trap. I need to know what year this was deemed mandatory so i can find out if the manufacturer of my mobile home is responsible for the cost of fixing this. Over time these traps can become clogged up with sediment and if this happens your boiler may stop working. According to the national fuel gas code sediment traps are required on gas furnaces.

Therefore the gas appliance does not have any sediment entering the gas chamber. Aiming the gas flow straight down pushes anything caught in the gas line into the trap where it cannot enter the appliance gas chamber.